Step. 1
Press the latch ‘A’ in the direction of the arrow and open the camera back door ‘B’. Lift up the film rewind crank ‘C’ and place a new roll of film into the film chamber.
Step. 2
Push the rewind crank ‘C’ back into place. Pull out the film from the film canister and hook the 2nd hole onto the film take-up spool ‘D’. Slightly advance the film by turning the film advance wheel ‘E’.
Step. 3
Close the camera’s back door. Continue to advance the film by turning the film advance wheel ‘E’ until it stops. Press the shutter button. Repeat this procedure one more time. The Film Counter ‘F’ will now show number ‘1’, and the camera is ready for taking pictures.
Step. (Optional)
To enable flash, open the battery door and insert a “AA” alkaline battery into the battery chamber. Make sure that the battery is inserted in the correct polarities as indicated on the battery door.
Step. (Optional)
To enable flash, slide the flash button upward. Wait for the Flash Ready LED to glow in RED. Once it glows, the flash is ready for taking pictures. (Slide the flash button downward in order to disable it.)
Step. 4
After taking pictures on the entire roll of film, press the rewind button ‘G’. Turn the film rewind crank ‘C’ clockwise until all film is re-wound back into the film canister.
Step. 5
Open the camera back door. Lift up the film rewind crank ‘C’, and remove the film for processing.